MPEG-2 HD Decoder Codec Module
MCM Codec Modules Overview

SOC Mpeg Codec Modules (MCMs) are small yet powerful video processing PCBs designed to reduce the engineering effort needed to make use of our low-latency all-hardware video/audio Codec IP.

MCM Modules are built with all the IC and interfaces that our Codec IP cores need to process real-time video:

  • a high-performance Xilinx/Intel FPGA/SoC
  • DDR memory
  • Flash/EEPROM
  • Audio-codec capabilites
  • Run-time API interface

MCM modules are pre-loaded with firmware according to customer specifications. They are shipped as ready to use, plug-in-and-play Codec processing systems.

To use MCM modules, add a 204-pin card connector on your PCB, and you are ready to encode/decode/transcode up to 4K/60 video (3840x2160 at 60fps), at ultra-low latencies (as low as 0.25ms!).

Product Overview
Edge-connector Card Interface

MCM Modules interface to user PCBs via a standard 204-pin SODIMM connector. You may recognize this connector as the DDR3 SDRAM connector used for connecting high-speed RAM to PCs. Coincidentally, this connector is also well-suited for streaming uncompressed and compressed video data.

You may purchase this connector from various electronics parts suppliers:

MM80 Series Inline Module Socket Connector
Manufacturer: JAE Electronics
Mouser - MM80-204B1-1
204-pin DDR3 SDRAM SODIMM Connector
Manufacturer: TE Connectivity AMP Connectors
DigiKey - 2-2013289-1
Edge Connector Signals

Working reference designs may be licensed from System-On-Chip Technologies.

Uncompressed Video Signals
HD video signals

Video data is transferred on the HDMI_D[] data bus. Vertical sync and horizontal sync signals are used for frame synchronization.

10-bit capable systems use 10 bits per channel, 8-bit systems ignore the 2 lowest bits [1:0] (they can be set to '0').

Signal NameDir.Description
HDMI_CLKIVideo Clock
HDMI_D[17:0]IHDMI Luma and Chroma Data
Video Clock

VIDEO_CLK is driven by the video source (usually HDMI or SDI chipset). VIDEO_CLK frequency should be set according to the resolution and framerate of the video source:

Resolution /FPSClock Frequency
640x480p 60fps27 Mhz
1280x720p 60fps74.25 Mhz
1920x1080p 30fps74.25 Mhz
1920x1080p 60fps148.5 Mhz
Compressed Data Stream Signals

Compressed data is transferred as an 8-bit stream over TS_BYTE[7:0] lines. At every rising edge of TS_CLK, if TS_DV is '1', this means that the current data on the TS_DATA bus is valid for reading.

Signal NameDir.Description
TS_CLKIStream Clock
TS_RDYOReceiver Ready
TS_DVIData Valid
TS_BYTE[7:0]IStream Data
UART Signals (API)

Modules expose a serial UART interface for reading/writing API registers. For a list of available API registers, refer to the API Guide.

Signal NameDir.Description
UART_RXIUART data to module
UART_TXOUART data from module

The standard UART protocol uses these parameters:

BaudrateData bitsStart bitsStop bitsParity bits
Voltage Requirements

Working reference designs may be licensed from System-On-Chip Technologies.